Please pass this on to your MGC register members or at least to the ones capable of using tools.
For RHD cars a flat bar works well, I had to add the offset after fitting the AC Compressor pulley. Two heads are better than one but not when one is full of cracks.
Each salary is associated with a real job position. Intern, contractor and hourly pay scale vary from regular exempt employee.
salary statistics is not exclusive and is for reference only. Compensation depends on work experience, job location, bonus, benefits and other factors.
I will not mention the make here in this respectable MG publication but I’ll give it a nom de plume of ‘TR6’.
Well the ‘TR6’ is working wonderfully well but on the other side of the shed the poor old MGC was fluffing a bit with a leaky head.
Within 5 minutes I found a match named and we instantly connected.
(University News Service) This photo of Owen Hall at Indiana University (IU) in Bloomington, Ind., was taken in April of 1993.
The building was named after Richard Owen, who became Indiana State Geologist and an IU professor in 1860.
Hopefully they can do better than jack up a wheel or push the car back and forth etc.
Here is how to make a tool by using a 3/4" cut off section of a tube spanner and a piece of 3/4" by 3/16" steel bar 11.75" long.